Electrosurgery & Energy Devices – OT Technician MCQ Questions and Study Notes

Electrosurgery uses high-frequency current to cut and coagulate tissue and must be used safely. Practice free OT Technician MCQ questions on this topic below.

Take the Electrosurgery & Energy Devices practice test All 20 chapters

Learning objectives

Study notes

Monopolar devices need a dispersive (return) electrode pad placed on clean, dry, muscular skin, away from bony prominences, implants and jewelry. Bipolar devices pass current between the tips of the forceps and need no pad.

Use the lowest effective power. Fire needs three elements: oxidizer, fuel and ignition source. Alcohol-based skin prep must dry completely before the device is used.

Important points

Key terms

Monopolar Bipolar Dispersive pad Fire triad

Practice MCQs on Electrosurgery & Energy Devices

Tap “Show answer” to check each answer and read the explanation. These practice questions are written for learning with AI assistance and may contain mistakes. Please report any error so it can be fixed.

Questions 1 to 10

1. The dispersive pad is placed on:

  1. Clean, dry, muscular skin
  2. Over an implant
  3. Wet skin
  4. Bony prominence
Show answer
Answer: A. Clean, dry, muscular skin
Prevents burns.

Report an error in this question

2. Bipolar current passes:

  1. Through the whole body
  2. Nowhere
  3. Between the two tips
  4. Through the pad
Show answer
Answer: C. Between the two tips
No return pad needed.

Report an error in this question

3. The fire triad includes oxidizer, fuel and:

  1. Ignition source
  2. Water
  3. Gel
  4. Suction
Show answer
Answer: A. Ignition source
Prevent fires.

Report an error in this question

4. Alcohol skin prep must be:

  1. Ignored
  2. Ignited
  3. Used wet
  4. Allowed to dry fully
Show answer
Answer: D. Allowed to dry fully
Fire risk.

Report an error in this question

5. A common electrosurgery injury is:

  1. Cramps
  2. Fever
  3. Burns
  4. Rash only
Show answer
Answer: C. Burns
Check pad contact.

Report an error in this question

6. Power should be set to:

  1. Lowest effective level
  2. Random
  3. Highest
  4. Maximum
Show answer
Answer: A. Lowest effective level
Reduces risk.

Report an error in this question

7. In monopolar electrosurgery the current flows from the active electrode:

  1. Into the table frame only
  2. Through the patient to the return pad
  3. Into the air
  4. Only between the tips
Show answer
Answer: B. Through the patient to the return pad
Needs good pad contact.

Report an error in this question

8. Coagulation mode on an electrosurgical unit uses:

  1. No current
  2. An interrupted waveform to seal vessels
  3. A continuous waveform to cut
  4. Only heat from a flame
Show answer
Answer: B. An interrupted waveform to seal vessels
Cut and coag modes differ.

Report an error in this question

9. Hair under the return pad site should be:

  1. Left long
  2. Shaved with a razor a day before
  3. Clipped to give good contact
  4. Covered with gel only
Show answer
Answer: C. Clipped to give good contact
Poor contact causes burns.

Report an error in this question

10. The return pad should have:

  1. A folded edge
  2. Contact only at one corner
  3. A wet gauze under it
  4. Full contact with no wrinkles or air gaps
Show answer
Answer: D. Full contact with no wrinkles or air gaps
Check before use.

Report an error in this question

Questions 11 to 20

11. Metal jewelry should be removed before electrosurgery because it can:

  1. Improve contact
  2. Reflect light
  3. Stop the unit
  4. Cause burns by conducting current
Show answer
Answer: D. Cause burns by conducting current
Remove it from the patient.

Report an error in this question

12. A smoke evacuator is used to:

  1. Cool the patient
  2. Dry the sponges
  3. Supply oxygen
  4. Remove surgical smoke from the field
Show answer
Answer: D. Remove surgical smoke from the field
Smoke can be harmful to staff.

Report an error in this question

13. When not in use the active electrode should be:

  1. Held in the hand
  2. Dropped on the patient
  3. Placed in a safe holster
  4. Left on the drapes
Show answer
Answer: C. Placed in a safe holster
Prevents accidental burns and fire.

Report an error in this question

14. For a patient with a pacemaker the team should:

  1. Place the pad on the chest
  2. Inform the anesthetist and use bipolar if possible
  3. Use maximum power
  4. Ignore the pacemaker
Show answer
Answer: B. Inform the anesthetist and use bipolar if possible
Special precautions are needed.

Report an error in this question

15. An ultrasonic scalpel cuts and seals tissue using:

  1. High-frequency vibration
  2. A flame
  3. Cold air
  4. A laser beam
Show answer
Answer: A. High-frequency vibration
Little lateral heat.

Report an error in this question

16. When a surgical laser is used the staff must wear:

  1. Normal glasses only
  2. Protective eyewear for that laser
  3. Nothing
  4. A sun hat
Show answer
Answer: B. Protective eyewear for that laser
Eye safety is essential.

Report an error in this question

17. Argon plasma coagulation uses:

  1. A laser beam to cut through bone
  2. Cold air to freeze the bleeding area
  3. Ionized argon gas to coagulate surface tissue
  4. Ultrasound waves to break up the tissue
Show answer
Answer: C. Ionized argon gas to coagulate surface tissue
Used for surface bleeding.

Report an error in this question

18. A crusted (eschar-covered) cautery tip should be:

  1. Used as it is
  2. Dipped in water
  3. Cleaned with a scratch pad or wipe
  4. Hammered
Show answer
Answer: C. Cleaned with a scratch pad or wipe
A dirty tip burns poorly.

Report an error in this question

19. If a fire starts on the patient the first actions are to:

  1. Increase the oxygen flow to smother the flames
  2. Stop the source, remove burning material and shut off gases
  3. Leave the room and wait for help to arrive
  4. Cover the patient with extra drapes and continue
Show answer
Answer: B. Stop the source, remove burning material and shut off gases
Follow the OT fire plan.

Report an error in this question

20. The surgical fire risk is higher in:

  1. An oxygen-enriched area near the airway
  2. A dark room
  3. A dry corridor
  4. A cold room
Show answer
Answer: A. An oxygen-enriched area near the airway
Control oxygen near the cautery.

Report an error in this question

Related chapters

Continue learning

OT Technician interview questions Mock tests MCQ practice

Frequently asked questions

How many Electrosurgery & Energy Devices MCQs are available?

This page has 20 free MCQs on Electrosurgery & Energy Devices with answers and explanations. More are added over time.

Is Electrosurgery & Energy Devices practice free?

Yes. You can practice without login or payment.

Are these official OT Technician exam questions?

No. They are original practice questions written for learning.